(NEW) Rampage Arrows and Shafts

         The Black Eagle Rampage is a precision-engineered arrow designed for exceptional hunting performance. With a 5mm (.204") inner diameter, this arrow the first 5mm that provides the perfect balance of speed, strength and penetration. Super-Sorted for unmatched consistency, the Rampage delivers; precise spine, straightness and weight tolerances to ensure optimal flight characteristics, in every single arrow.  Ideal for big game hunting, the Rampage is built to exceed your expectations in the toughest hunting conditions.

Safety First

Fletched 6pk INCLUDE:

• 6, Stainless Steel Bone Crusher Half-Outs - 50 Grains Ea.
• 6 Nock Collars 3 Grains Ea.
• 6, Installed BEA R-Nocks (Orange) - 7 Grains Ea.
• 2.5" Q2I Fusion X-II Shield Cut Vanes | Red, White Vanes - 8 Grains Ea.
• 6 pk Box with 6 Hand fletched arrows

12pk shafts INCLUDE:

• 12, Stainless Steel Bone Crusher Half-Outs - 50 Grains Ea.
• 12 Nock Collars 3 Grains Ea.
• 12, Installed BEA R-Nocks (Orange) - 7 Grains Ea.
• 12 pk Box with 12 shafts

Fletched 36pk INCLUDE:

• 36, Stainless Steel Bone Crusher Half-Outs - 50 Grains Ea.
• 36 Nock Collars 3 Grains Ea.
• 36, Installed BEA R-Nocks (Orange) - 7 Grains Ea.
• 2.5" Q2I Fusion X-II Shield Cut Vanes | Red, White Vanes - 8 Grains Ea.
• 36 pk Box with 36 Hand fletched arrows

Customize your components Here

To install the Half-Out.
 

1. Square the end of the arrow shaft
2. Dry fitting is recommended on all components. Slide half-out in shaft and spin test (if you prefer)
3. If a slight wobble is noticed, DON'T PANIC! Rotate the half-out with field point installed until the spin is true.
4. Again, Rotate Half-Out until it spins perfect.
5. Use a Silver or Black Sharpie and mark the Shaft and the Half-Out for perfect alignment once glue is applied.
6. We have tested Our fletching glue, insert/outsert glue and epoxy and all of them work great.
7. Apply a even amount of glue around the shaft of the Half-Out to ensure the glue channels get enough glue in them to hold.
8. Once the glued half-out is finished stand the arrow on the point to dry

Specifications

Not sure what size is right for you. Check out our sizing chart.

Hot Melt is NOT recommended for use with Black Eagle Arrow shafts.
NO Cleaner for Outside or Inside the shaft is recommended! Use Q-Tip or Paper towel.