Description
To install the Half-Out.
- Square the end of the arrow shaft
- Dry fitting is recommended on all components. Slide half-out in shaft and spin test (if you prefer)
- If a slight wobble is noticed, DON'T PANIC! Rotate the half-out with the field point installed until the spin is true.
- Again, rotate half-out until it spins perfectly.
- Use a silver or black Sharpie and mark the shaft and the half-out for perfect alignment once glue is applied.
- We have tested our fletching glue, insert/outsert glue, and epoxy, and all of them work great.
- Apply an even amount of glue around the shaft of the Half-Out to ensure the glue channels get enough glue in them to hold.
- Once the glued half-out is finished, stand the arrow on the point to dry.
Reviews
36 Reviews
-
Nice inserts
Quality products black eagle is my go to arrow shafts and components
-
Customer review
Review body is empty
-
Great product
All my Black Eagle products have been great and these are no exception. Recommend
-
Love these things. Hard hitting and accurate
Wish I had gotten them a lot sooner. They hit hard enough that they are blowing through some of my targets. The same target my precious arrows were not blowing through
-
Quality
So far I’ve been very impressed with the quality and tolerances for the components and arrows vs my other previous brand.
-
Wrong order sent
I either ordered the wrong insert by mistake or was sent the wrong inserts. I need to send them back and receive the next size up.
-
Customer review
Review body is empty
-
Half Out
I'm admittedly a little bit of a nut when it comes to the details.. I researched as much as I could about accurizing and building arrows as I could find, did a bunch of experimentation with fletching, FOC, various arrow weights, spine alignment and nock tuning. Wound up going with a .300 spine rampage, with a 50 grain screw in brass insert weight, a 50 grain stainless steel half out, 7 inch bohning white wraps, bhoning heat vanes in a 3 flectch left helical configuration. This setup on my Bowtech SS @ 70#'s with a 29 inch draw length is crazy accurate. I can't shoot at the same spot on my target or I will split arrows. I split one tonight all the way to the insert, and center punched the nock onto my field tip so squarely that I had to use a pair of vice grips to remove it from the field tip.
-
Arrows and half outs
Rampage arrows...awesome grouping and penetration! Fast shipping, fast receipt, fantastic company. Very impressed.
