Black Eagle X-Impact Outserts
14 reviews
Confidence Starts Here.
Trusted when the moment matters most.
Quantity per pack: 12
These black anodized 7075 T6 aluminum alloy outserts have been tested and designed by experienced hunters and target archers to ensure maximum penetration and performance. This outsert fully encompasses the base of the shaft just over 1 inch, providing OUTSTANDING arrow strength and concentricity. With Micro-Glue channels inside the outsert to create a much better bonding surface, this outsert is built to last shot after shot. If you are looking for maximum penetration and shot-after-shot performance, then the deadly combination of the Deep Impact or X-Impact shafts and this outsert is sure to be a hit!
The Deep Impact & X-Impact Outsert Weights are as follows:
-
250 Spine = 42 Grains
300 Spine = 40 Grains
350 Spine = 44 Grains
400 Spine = 46 Grains
500 Spine = 48 Grains
To install the outsert.
- Select the right outsert for the right shaft.
- Dry fitting is recommended on all components. Slide Outserts over shaft and spin test (if you prefer)
- If Outserts does not fit, that is OK. Get some 100 grit sandpaper and lightly sand the shaft in a circular motion until the insert fits snugly on the shaft. Start slowly so you don't remove too much of the arrow.
- Wipe dust off of the shaft with a clean paper towel. (No Cleaners are recommended.)
- Again, spin test to ensure concentricity. Rotate the outsert until it spins perfectly.
- Use a silver or black Sharpie and mark the shaft and the outsert for perfect alignment once glue is applied.
- We have tested our fletching glue, insert/outsert glue, and epoxy, and all of them work great.
- Apply an even amount of glue around the shaft to ensure the glue channels get enough glue in them to hold.
- Once the outsert is glued on, stand the arrow on the nock end to dry.
