The Rampage Front Of Center Outsert System F.O.C.O.S (Patented) is a revolutionary product in the Components category. This outsert system is designed to improve the performance and accuracy of arrows by shifting the weight forward to enhance front-of-center balance. Its patented design ensures superior durability and easy installation. By optimizing the F.O.C.O.S system, this product guarantees enhanced arrow flight and accuracy, making it a must-have for serious archers.
The F.O.C.O.S is made of 3 parts. One is a black anodized 7075 T6 aluminum alloy outsert. Two is a Stainless steel Retention post that also acts as a footer inside the shaft. The third part is the 3/32 allen head retention screw that allows for the Outserts to either be screwed on or screwed and glued.(Not Tattooed) This system has been tested to over 550 Pounds per square inch of pull and they stay on! If you are looking for maximum penetration, Maximum F.O.C and shot after shot performance then the deadly combination of the Rampage arrows then the F.O.C.O.S is sure to be a hit!
Rampage F.O.C.O.S Outserts use FOCOS Brass Weights if you are adding extra weight
- To install the F.O.C.O.S System
- Select the right outsert for the right shaft.
- Glue in Stainless steel retention Post
- Dry fitting is recommended on all components. Slide Outserts over shaft and spin test (if you prefer)
- If Outserts does not fit that is OK. Get some 100 Grit sand paper and lightly sand the shaft in a circular motion until the outsert fits fairly snug on shaft. Start slowly so you don't remove to much off the arrow.
- You should have approximately 3/4 of an inch insertion on Aluminum Outserts
- Wipe dust off of the shaft with Clean paper towel. (No Cleaners are recommended)
- Again, Spin test to ensure concentricity.
- Use a Silver or Black Sharpie and mark the Shaft and the Outsert for perfect alignment
- Slide outsert over shaft and use the 3/32 Head retention Screw and Lock the Outsert in place!
- If using glue See steps 11-15 .
- We have tested Our fletching glue, insert/outsert glue and epoxy and all of them work great.
- Apply a even amount of glue around the shaft to ensure you get enough glue in them to hold.
- Slide Outsert On shaft rotating to make sure Glue/Epoxy is evenly dispersed
- Use the 3/32 Head retention Screw and Lock the Outsert in place! Loctite Purple or Blue recommended
- Once The outsert is glued on Screw is installed stand the arrow on the nock end to dry.
39 Reviews
-
Excellent as always
Was my first time trying the FOC system and it is awesome! As always finish and matching is perfect! Fit was perfect and arrows built with no wobble!
-
Very nice
You want FOC? Come get some! These are awesome! They extend your arrow 1.25" so if you want a 29" arrow, you can cut it at 27.75" saving some arrow weight and increasing FOC even more! Don't hesitate, they work and the end is flared to 5/16" for a smooth transition to most broadheads. Oh, and customer service... Sent a question in around midnight one night, thinking I'll hear back the next day... Nope! Had the response by 1230 and it was a Friday night! Well played Black Eagle, well played...
-
Great idea. Well implemented. WAY too expensive
Great execution especially for the Rampage. Paired with the FOCOS I can stay around 475 gr of arrow weight while still being greater than 19 percent FOC. That being said these are EXPENSIVE! Shipping too was exorbitant at 9 dollars for a package that weighed only 3 ounces. I'm sure there were R&D costs but at almost 50 bux delivered for JUST outserts I might look elsewhere next time.
